product description
product description
Self-leveling DURAL pedestal BA:
The DURAL self-leveling pedestals BA are suitable for laying terrace slabs, tiles and other ceramic tiles.
With their self-leveling function and automatic slope compensation of up to 5%, they enable easy and precise installation. The system is based on an intelligent plug-in principle that enables problem-free configuration and installation.
These bearings complement the heights of the Pedestal bearing MB. There are three different, height-adjustable versions:
- 47 - 62 mm
- 77 - 112mm
- 133 - 165mm
DURAL self-leveling pedestals BA are specially developed for outdoor use and are mainly used on balconies and terraces. Just make sure that the panels have a minimum thickness of 2 cm.
Technical data
Technical data
DURAL self-leveling paving pedestal BA properties:
| Material |
Plastic |
| Joint width |
2 mm |
| Top contact surface |
⌀ 120 mm |
| Bottom contact surface |
⌀ 190 mm |
| Load capacity |
up to 400 kg |
processing
processing
Installation of DURAL pedestal supports BA:
If required, an extension piece can be screwed into each support.
Depending on the size of the slab, a different number of supports per slab must be used.
- Preparation of the substrate:
The substrate must be load-bearing. Suitable substrates are e.g. concrete, wood or grit/gravel. When used in grit/gravel, 40 x 40 cm base plates must be installed. Depending on the construction situation, the substrate must also be properly sealed in advance and a DR80++ drainage mat laid if necessary. - Positioning the pedestals:
Start positioning the pedestals in a corner and adjust the height accordingly. Check the height for evenness using a spirit level. - Laying the slabs:
Finally, lay the slabs.
The lower support surfaces can be sawn off in the edge area so that they do not protrude sideways.
Care instructions
Care instructions
product safety
product safety
Angle profiles at a glance
Angle profiles at a glance
